Bavaria 36 Jib furling line

[MacLovin]

Where the heck is the jib furling line supposed to run?
I have a 2003 Bavaria 36.
There is one block attached at the pulpit, then the fairlead and cleat aft of the winch.
Where should it go in-between?
Thanks in advance.

[symphony2]

it runs through a slot in the stanchion base. Works OK but better to use stanchion fairleads from Harken, Selden, Spinlock, Barton etc.

[Keweetoo]

I found running the furling line through the stanchion base slots produced a lot of friction and dirt on the line. Fitting stanchion fairleads 100mm up was much better together with a cam cleat/right angle block aft.

[David Gray]

I have stantion mount eyelet and roller mount blocks fitted which you can buy from a y chandelry