Has anyone got a Cockpit Table / Instrument Pod like the attached? This is on a 2000 model Bavaria 47.
I need to move my microphone clip onto the upright as shown. The clip is perhaps 2mm wider, and curved, but I'm planning on putting on a backing plate.
I would like to make an approximation of the curve before I go to the boat, it is much easier at home. None of the pictures I have show the profile of the curve: for example is the face rounded or flat, what is the edge radius ... ?
If anyone has a table like this, could they do me a favour and measure the width near the tip of the arrow, and cut a bit of card to fit the profile, then post it here?
I can do that for you Nigel. I'll be down there next weekend.
Bob
Anyone else?