Battery Charging

Started by Scorcher IV, September 13 2024, 17:54

Previous topic - Next topic

Scorcher IV

Hi,
I have replaced the two old 120Ah Varta batteries on my B37 with new 2 new 190Ah and a new starter battery, all Varta. I have a Quick SBC 500 battery charger and a standard 115amp alternator, can anyone tell me if I have enough charging capacity with the shore power charger and the alternator when underway to adequately charge the new bank as it feels as though they discharge very quickly when sailing.
Simon

tiger79

Yes, you have enough charging capacity.  How quickly did the old bank discharge when sailing?

Scorcher IV

Hi, towards the end of the original batteries life they discharged over a day sail, these new larger don't seem to hold the charge any better despite being a lot bigger. I have not had any breakers trip so i doubt I have a short anywhere, I wonder if my panel gauge is working correctly and telling the truth.

symphony2

Suggest you fit a battery monitor so that you know more accurately your pattern of charging and consumption. You have more than enough potential capacity and charging.

Diverphil1

You will get a slightly lower reading at the gauge than if you test directly at the battery terminals. I think ours reads about 1/4 volt less at the standard gauge. I'm not sure if you can re-calibrate the gauge or not. Try and check the voltage at the battery when charging with shore power and when charging with the engine.

Scorcher IV

Any suggestions on a good battery monitor?

tiger79

Quote from: Scorcher IV on September 15 2024, 09:13
Any suggestions on a good battery monitor?

For a basic monitor, look at the Victron BMV700 or 702.  If you want something more versatile with a better display, look at the Simarine Pico - I fitted one of these a few years ago and it's been great.


SYJetzt

The standard voltmeter doesn't show the state of charge (SOC), but only the voltage. The only way to get a correct SOC is with a battery monitor. An existing charge splitter (usually the old ones with diodes) may affect the SOC, if the alternator sensor cable isn't wired correctly. Maybe you didn't wire it correctly after changing your batteries.